Drill America DWTT3/4-10 3/4"-10 Carbon Steel Taper Tap (Pack of 1), DWT Series, Uncoated (Bright)

Had a set of TeraFlex Long arms that had rusted badly sitting in Salt water .. I did not think they where salvageable.. But he TAP was cheep so i thought i would give it a go...Wow was i wrong ...A Bit a Lube and the tap cleaned up the threads so well .. New arms would of been a couple of hundred bucks and this TAP is my new friend, no more cutting off control arms bungs and rebuilding arms ..The best big is this 1.25 x 12TPI is used in All Rough Country, Rubicon Express and Jonny Joints so very little money for a great tool... Just add a 1 inch Socket to the top and fits ya impact

I'm fairly new to the tap and die world but doing more custom work on my motorcycles has forced me to step up my game. Consequently, I had to learn about the different types of taps and how they are used. This type of tap is designed to cut threads all the way to the bottom of the hole you're cutting threads into. It's especially useful (at least in my case) for tapping shallow holes where every thread counts in order to secure a fastener. I've been able to use this tap a few times now and so far it has performed great. Pair it with good cutting oil and a lot of patience and you can get great threads on even some of the hardest of metals.

Used to chase damaged threads in locking nut.. This tap repaired uncommon 12 tpi nylock nut that are not available locally and machinery out of commission. Tap got it up and running doing a fantastic repair job, quality outstanding

I bought the set for a one-time use of this odd size (M13x1.5). Price was right at about 1/3 the cost of other taps but the steel isn't top quality. The worked well to cut the threads I needed in cast 6061 aluminum. They came out clean, sharp and accurate but I don't think the taps will hold up for the long haul.They're a very good value for limited use. If you need to cut a lot of threads or plan to keep them for years, you'd be better off spending more and getting better quality tools.

Worked great for cutting new threads in my tractor hub to replace lug studs with lug bolts. Old lug nuts were over torqued and made it impossible to remove nut from stud. The whole stud would come out instead of taking nut off.

Needed this quick for a project worked great and got here in a day

My order was received quickly, but I ordered a 7/16 x14 tap but received a 14 MM tap instead. I found the correct tap, though it was poor quality to do the job.

Just what I ordered, would buy again.